Guangdong Crown Paint Company Limited

Glossy Epoxy Wall Paint

  • main raw material: Epoxy Resin
  • Suitable for factory,Shopping Mall,Garages,Hotel,Commercial Plaza,Showroom,etc.
  • Usage: indoor floor coating decoration protection waterproofing
  • Application tool: roller,spray
  • State: Liquid Coating
BASIC INFO
CP-142 is a two-component epoxy solvent paint. It can be applied in the cold and moist environment, especially in the wet and humid areas. The coating is hard and wear-resistant. Large range of colors for choice and it is mainly used for the interior wall of light industrial workshop, warehouse, parking lot etc.

CP-30 is a two-component solvent epoxy primer. It has good penetration and sealing power on the porous substrate, such as concrete and water whetstone, etc. It can reinforce the substrate strength and provide good adhesion.
It is also an all-purpose primer for epoxy series paints and used as the undercoat or putty coat after used together with quartz sand or quartz powder.

Advantages:

1. Beautiful, seamless, dustproof and easy to clean.
2. Strong adhesion, small shrinkage 
3. Corrosion-resistance to the general chemicals.
4. Good abrasion resistance and durability.

Requirements for the base:

1. Concrete strength≥C25;
2. Flatness: the maximum altitude difference of 2M running rule<3mm. 
3. The moisture content of the base<4%

Technical Data:

Drying time:
Touch dry: 4 hours
Hard dry: 2--4 days
Compressive strength (Mpa): 80
Impact resistance strength (Kg•cm): 40 
Flexural strength (Mpa): 40
Adhesive force grade: 1
Pencil hardness (H): 2
Abrasion resistance(750g/1000r, zero gravity, g)≤0.03
Service life: 5-8 years

Recommended Consumption:

Primer: 0.15kg/sqm
Top coat: 0.3kg/sqm

Application instructions:

1. Surface preparation:Correct substrate preparation is critical for optimum performance. Surface should be sound, clean, dry and free from loose particles, oil, grease, and other contaminants.
2. Primer: Mix CP-30A and CP-30B in a barrel according to 1:1 by weight. The reference consumption is 0.15kg/㎡.The main purpose of this primer is to seal the substrate completely and avoid air-bubbles in the body coat. According to the oil absorption condition of substrate, a second coat may be required. The paint should be stirred evenly, then apply directly with roller. Wait for 8 hours to recoat. 
Inspection standard for the primer: even film with certain brightness.
3. Top coat: Mix CP-142A and CP-142B according to 3:1 and then apply the mixture with roller for twice. The second layer must be applied after 12 hours. 
4. Maintenance: 5-7 days. Don’t use or wash with water or other chemicals.

Clean up

Clean tools and equipments first with paper towels, then clean the tools with solvent before the paint hardens



Previous :
Next: